Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Norm Fengstad

Pages: [1] 2 3 ... 17
1
General Scroll Saw Talk / Re: Seyco saw
« on: February 27, 2024, 07:01:26 am »
perhaps  by turning the motor slightly will change the for and aft alignment. sideways alignment if the table is perfect then some adjustments can be done at the blade clamp brst to call Seyco they, in the past, always gave me great advice

2
Ask Steve a question. / Re: Keep membership active
« on: December 30, 2022, 08:45:58 pm »
hi we are neighbors

3
General Scroll Saw Talk / Re: Lemon oil
« on: March 21, 2022, 09:38:09 am »
Never used lemon oil

4
I live in Canada as well and have purchased blades from Saw Bird, Mike's and Denny Knappen all are excellent suppliers and pricing is similar and all provide quality service. Saw Bird is in the same Province as me so I tend to shop local.

5
Intarsia / Re: 1928 Ford Truck
« on: January 02, 2022, 05:18:42 pm »
 your work is inspirational  I thanks for sharing

6
Intarsia / Re: 1941 Chev Coupe
« on: January 02, 2022, 05:15:26 pm »
So perfect and brings back memories

7
Intarsia / Re: 1st. Practice
« on: January 02, 2022, 05:13:19 pm »
treasure for a little boy to carry him through life

8
Intarsia / Re: Billy the Kid 55' Boat
« on: January 02, 2022, 05:10:54 pm »
The way it runs out of the picture frame ,is very effective

9
Intarsia / Re: 1941 Chev Coupe
« on: November 26, 2021, 05:08:15 pm »
very good

10
Brag Forum / Re: Tealight holder
« on: November 09, 2021, 07:58:24 am »
eye catcher for sure looks like mahogany is that what you cut

11
Brag Forum / Re: Redeeming Myself
« on: November 09, 2021, 07:56:45 am »
four light coats with fine sanding after each layer is worth the effort

12
Brag Forum / Re: Clook
« on: November 09, 2021, 07:54:39 am »
looking good

13
Brag Forum / Re: Wine
« on: October 18, 2021, 08:21:00 am »
Steve,s patterns are great and he is a mentor to most scrollers

14
Brag Forum / Re: Advent Candle Wreath
« on: October 18, 2021, 08:19:39 am »
thanks for sharing

15
Brag Forum / Re: Horse and Girl
« on: October 18, 2021, 08:18:57 am »
Great cut, Jim Blume is an astounding pattern maker

Pages: [1] 2 3 ... 17

SMF

Teknoromi